Back to installation guides

Setting up the 360 rotating cylinder head stand (BPPCHES)

Bolt selection, mounting, locking the rotation, and working safely on a head held by its end bolt holes.

The 360 cylinder head stand is simple to set up, but a head that is not bolted down solid is dangerous, so take the two minutes to do it right.

WHAT YOU NEED

The stand with its hardware kit, which includes 8mm, 10mm, 3/8 inch and 7/16 inch bolts with washers. A solid bench or stand base. The right size wrench for the bolts you use.

SETTING IT UP

1. Put the stand on a solid surface at a height where you can work on the ports without hunching. A stand that can tip is worse than no stand.

2. Match the bolt size to the end bolt holes in your head. LS and Gen V heads, Hemi, 318 and 360, big and small block Chevy and Ford are all covered by the kit, but that only helps if you pick the bolt that threads in cleanly by hand.

3. Thread the bolts in by hand first. If a bolt is cross threading, you have the wrong size, so try the next one rather than forcing it.

4. Snug the bolts evenly, alternating side to side, until the head will not shift when you push on it. Do not hang off the wrench on an aluminum head.

5. Unlock, rotate, relock. The stand locks at any angle, so set the angle you want and lock it before you put any force into a port or a spring.

WORKING SAFELY

Never rotate the head with the lock loose and your hand under it. Aluminum heads are heavy and the edge of a casting will win that argument.

If you are changing valve springs on the bench, the head bolts to the stand the same way and you work with both hands free.

If your head uses a bolt size the kit does not cover, call us at 606-627-7960 before you buy and we will tell you what you need.

Reviewed by Bluegrass Performance, November 2026.

Tools used in this guide

Bluegrass performance® 360 Rotating Cylinder Head Stand

SKU: BPPCHES

Add to Cart