Using the Gen V LT valve spring compressor (BPPLT1DVST)
Gen V 5.3 and 6.2 L83, L86, LT1 and LT4 procedure, what the tool fits, and why an LS tool does not work here.
The Gen V LT head is not an LS head with a different name. The rocker layout and the pad the tool sits on are different, which is why our BPPLT1DVST exists and why an LS compressor will sit crooked on these engines. This is how we recommend using it.
WHICH ENGINES THIS COVERS
Gen V covers 5.3 and 6.2 V8s from 2014 forward: L83, L84, L86, L87, plus the 6.6L L8T gas engine. Car engines are LT1, LT2, LT4 and LT5. That is C7 and C8 Corvette, Camaro SS and ZL1, Cadillac CTS-V, CT5-V Blackwing and Escalade, and the truck and SUV engines.
It does not fit the 1992 to 1997 5.7L LT1, which is a small block. It does not fit Gen III or Gen IV LS engines. It does not fit the LT6 or LT7 flat plane engines, or any diesel.
WHAT YOU NEED
The Gen V compressor with its replaceable stud and mounting hardware, compressed air with a spark plug adapter or clean rope, a magnet for keepers, replacement springs, retainers, locks and valve stem seals, and eye protection.
STEP BY STEP
1. Remove the valve cover and the rocker arms on the cylinder you are working on. Keep the hardware in order.
2. Bring the piston to top dead center on the compression stroke so nothing can fall into the cylinder.
3. Pressurize the cylinder through the spark plug hole, or feed rope in and bring the piston up. Hold the valves closed the whole time the spring is off.
4. Set the compressor on the head. It should sit flat against the head surface, not rock on a casting edge. Snug the mounting hardware.
5. Compress the spring until the retainer clears the keepers, pull the keepers with a magnet, and lift the retainer.
6. Replace the spring, retainer, locks or seal.
7. Refit the retainer and keepers, check they are seated, then release the compressor slowly.
8. Reinstall the rockers and torque to the factory specification for the engine.
9. Release the air or pull the rope, refit the plug, and move to the next cylinder.
ABOUT THE REPLACEABLE STUD
The stud is the part that wears, so we made it replaceable. If the tool starts feeling loose or the threads show wear, replace the stud rather than the tool. Contact us and we will get one to you.
IF IT DOES NOT FIT
If the tool will not sit flat on your head, stop. Two things cause this: the head is not a factory-style Gen V head, or there is debris on the mounting surface. Call 606-627-7960 before you force anything.
Reviewed by Bluegrass Performance, November 2026.
Tools used in this guide
Bluegrass Performance® Gen V Valve Spring Compressor Tool for 5.3L, 6.2L L83, L86, LT1, and LT4 Engines
SKU: BPPLT1DVST
Add to Cart