Back to installation guides

Using the LS valve spring compressor (BPPDVST)

Step by step on LS1, LS2, LS3, 4.8, 5.3 and 6.0 engines with the heads on the car, plus troubleshooting.

This is the procedure we recommend for our BPPDVST LS valve spring compressor on LS1, LS2, LS3, 4.8, 5.3 and 6.0 engines with the heads on the car.

BEFORE YOU START

You need: the LS compressor, a valve spring compressor is not a one handed job, so plan on both hands free. Compressed air with a spark plug hole adapter, or clean rope, to hold the valves closed. A magnet or a small pick for keepers. New springs, retainers, locks and valve stem seals if you are replacing them. Eye protection, always.

Work one cylinder at a time and keep every valve you take apart identified so it goes back where it came from.

STEP BY STEP

1. Remove the valve cover and the rocker arms for the cylinder you are working on. Keep the rockers and bolts in order.

2. Bring that piston to top dead center on the compression stroke. If a valve drops, the piston stops it before it goes into the cylinder.

3. Pressurize the cylinder through the spark plug hole or feed rope in through it and bring the piston up to hold it. Either method keeps the valves up while the spring is off.

4. Mount the compressor on the head using the supplied Grade 8 hardware. Snug it down evenly so it sits flat.

5. Compress the spring until the retainer lifts clear of the keepers, then remove the keepers with a magnet and take the retainer off.

6. Change the spring, retainer, locks or valve stem seal as needed.

7. Put the retainer and keepers back, release the compressor slowly, and confirm the keepers are seated before you move on.

8. Reinstall the rocker arms and torque them to the factory specification. Do not guess at this number.

9. Pull the air pressure or the rope, reinstall the spark plug, and repeat on the next cylinder.

TROUBLESHOOTING

The keepers will not release: make sure the spring is fully compressed. On a used engine, a light tap on the retainer with a brass drift while the spring is compressed usually frees them.

The tool will not sit flat on the head: check that the rocker pedestal surface is clean and that you are not over a casting boss. The tool should not rock.

A valve starts to drop: stop, get the piston back to top dead center, and restore your air or rope before continuing.

IF YOU HAVE A GEN V ENGINE

Stop here. This tool is for LS engines. Gen V heads, which include 2014 and newer 5.3 and 6.2, LT1, LT4 and LT5, take our BPPLT1DVST tool, and this one will not sit correctly on them.

Questions while you are in the middle of the job? Call 606-627-7960, Monday through Friday, 9 to 5 Eastern.

Reviewed by Bluegrass Performance, November 2026.

Tools used in this guide

Bluegrass Performance® 4.8 5.3 6.0 LS1 LS2 LS3 Valve Spring Compressor Tool | GM Chevy and Mopar Engines |

SKU: BPPDVST

Add to Cart